Typical Malfunction Thresholds
WARNING: This page is about a different variant/trim than selected.
| Either of the following conditions is met | 1 or 2 |
| 1. Both of the following conditions A and B met | - |
| A. Engine speed - Target engine speed | Less than -100 rpm, or higher than 150 rpm |
| B. Idle control correction value | -7 Nm or less, or 15 Nm or more for 5 seconds or more |
| 2. Both of the following conditions C and D met | - |
| C. Frequency that all of following conditions (a), (b) and (c) met | 5 times or more |
| (a) Engine speed - Target engine speed | Less than -100 rpm, or higher than 150 rpm |
| (b) Idle control learning value (value when last idle) | -5 Nm or less, or 10 Nm or more |
| (c) Vehicle condition | Stopped after being driven at 10 km/h (6.25 mph) or more |
| D. Amount of change Idle control correction value | -12.09 Nm or less, or 7.16 Nm or more |