DTC P0110-2A: Intake Air Temperature Sensor 1 Bank 1 Signal Stuck in Range [06/2020 - 08/2020]: Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0110-2A)
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine / Trouble Codes.
- Read the DTCs.
Powertrain > Engine > Trouble Codes
Result
Result Proceed to DTC P0110-2A and other DTCs are output A DTC P0110-2A is output B HINT:
- If any DTCs other than P0110-2A are output, troubleshoot those DTCs first.
- Perform "Inspection After Repair" after replacing the mass air flow meter sub-assembly.
Refer to INITIALIZATION [10/2019 - 08/2020]
Result:
A
GO TO DTC CHART
Refer to DIAGNOSTIC TROUBLE CODE CHART [06/2020 - 08/2020]
Result:
B
REPLACE MASS AIR FLOW METER SUB-ASSEMBLY
Refer to REMOVAL [02/2019 - 08/2020]