How To Proceed With Troubleshooting [12/2015 - 11/2017]: Procedure

Result

Result: 

NEXT 

See step  2

Standard voltage

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

Result

Result: 

NG 

CHARGE OR REPLACE BATTERY 

Result: 

OK 

See step  3

1. Use the Techstream to check if the CAN communication system is functioning normally (See reference. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [12/2015 - 08/2016] Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2016 - 11/2017] ).

   Result

   Result	Proceed to
   CAN DTC is not output	A
   CAN DTC is output	B

Result: 

B 

GO TO CAN COMMUNICATION SYSTEM 

(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [12/2015 - 08/2016] Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2016 - 11/2017] )

Result: 

A 

See step  4

1. Check for DTCs (Refer to DTC CHECK / CLEAR [12/2015 - 11/2017] ).
   1. Record the DTCs.
2. Clear the DTCs.
3. Recheck for DTCs.
   1. Attempt to duplicate the malfunction and check if the DTCs are output again (Refer to DTC CHECK / CLEAR [12/2015 - 11/2017] ).

   Result

   Result	Proceed to
   DTC is not output	A
   DTC is output	B
   No DTC is output, and malfunction cannot be duplicated or checked	C

Result: 

B 

GO TO DTC CHART 

(Refer to DIAGNOSTIC TROUBLE CODE CHART [12/2015 - 11/2017] )

Result: 

C 

GO TO SYMPTOM SIMULATION 

(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [12/2015 - 08/2016] Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2016 - 11/2017] )

Result: 

A 

See step  5

Refer to Problem Symptoms Table (Refer to PROBLEM SYMPTOMS TABLE [12/2015 - 11/2017] ).

Result

Result: 

B 

See step  7

Result: 

A 

See step  6

1. Data List / Active Test (Refer to DATA LIST / ACTIVE TEST [12/2015 - 11/2017] )
2. Terminals of ECU (Refer to TERMINALS OF ECU [12/2015 - 11/2017] )

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  7

Result

Result: 

NEXT 

See step  8

Result

Result: 

NEXT 

END