LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2019 >> Tundra TRD Pro >> Repair and Diagnosis >> Body & Frame >> Windows >> Power Window Control System (W/ Jam Protection Function) - Diagnostic Codes & Symptom Tests >> POWER WINDOW CONTROL SYSTEM (w/ Jam Protection Function) >> DTC B2312: Power Window Switch Malfunction [08/2017 - ] >> Description
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC B2312: Power Window Switch Malfunction [08/2017 - ]: Description

The power window regulator sub-assembly consists of the motor, regulator and ECU. The power window regulator motor is driven by operating the power window switch. This DTC is output when the ECU built into the regulator motor determines that the power window switch is stuck.

NOTE:
  • When the power window regulator motor is reinstalled or replaced, the power window control system must be initialized.
  • After a door glass or a door glass run has been replaced, the jam protection function may operate unexpectedly when the AUTO UP function is used. In such cases, the AUTO UP function can be resumed by repeating the following operation at least 5 times:

    (a) Close the power window by fully pulling up the power window switch and holding it in the AUTO UP position.

    (b) Open the power window by fully pushing down the power window switch.

MASTER SWITCH

DTC Code DTC Detection Condition Trouble Area
B2312
  • The power window regulator master switch is stuck.
  • The power window regulator master switch is held in the same position for more than 20 seconds.
  • Power window regulator master switch assembly
  • Harness or connector
  • Power window regulator master switch assembly held in same position for more than 20 seconds
DRIVER SIDE MOTOR

DTC Code DTC Detection Condition Trouble Area
B2312
  • The power window regulator master switch stuck.
  • The power window regulator master switch is held in the same position for more than 20 seconds.
  • Power window regulator master switch assembly
  • Front power window regulator motor assembly LH
  • Harness or connector
  • Power window regulator master switch assembly held in same position for more than 20 seconds
FRONT PASSENGER SIDE MOTOR

DTC Code DTC Detection Condition Trouble Area
B2312
  • The power window regulator switch is stuck.
  • The power window regulator switch is held in the same position for more than 20 seconds.
  • Power window regulator switch assembly
  • Front power window regulator motor assembly RH
  • Harness or connector
  • Power window regulator switch assembly held in same position for more than 20 seconds
scientia non olet · About LEMON Manuals