Driver Side Power Window does not Operate with Power Window Master Switch [08/2017 - ]: Procedure

1. Remove the front power window regulator motor assembly LH (Refer to REMOVAL [08/2017 - ] ).
2. Inspect the front power window regulator motor assembly LH (Refer to INSPECTION [08/2015 - ] ).

Result: 

NG 

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH 

(Refer to REMOVAL [08/2017 - ] )

Result: 

OK 

See step  2

1. Disconnect the N2 master switch connector.
2. Disconnect the N3 motor connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   N2-3 (U) - N3-2	Always	Below 1 Ω
   N2-4 (D) - N3-1	Always	Below 1 Ω
   N2-3 (U) or N3-2 - Body ground	Always	10 kΩ or higher
   N2-4 (D) or N3-1 - Body ground	Always	10 kΩ or higher

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  3

1. Remove the power window regulator master switch assembly (Refer to REMOVAL [08/2017 - ] ).
2. Inspect the power window regulator master switch assembly (Refer to ON-VEHICLE INSPECTION [08/2017 - ] ).

Result: 

OK 

GO TO POWER WINDOWS DO NOT OPERATE AT ALL 

(Refer to Power Windows do not Operate at All [08/2017 - ] )

Result: 

NG 

REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY 

(Refer to REMOVAL [08/2017 - ] )