Engine Stop And Start Ecu Configuration (Using As-Built Data) [07/2015 - ]

HINT: 

• If the configuration is performed using As-Built data, the set value of the personalization function is reset to the initial value (condition when shipped from factory). Verify the set value with the customer and perform the personalization function setting after performing the configuration using As-Built data.
• If the ignition cannot be switched ON (engine off), switch it ON (engine off) using the forced ignition ON function of the Techstream.

  Refer to INSTALLATION [07/2015 - ]

1. PID/DATA MONITOR INSPECTION [SMART KEY (ENGINE STOP AND START ECU)] 
   1. Connect the Techstream to the DLC3.
   2. Turn the engine switch on (IG).
   3. Turn the Techstream on.
   4. Enter the following menus: Body Electrical / Smart Key / Utility / Configuration.

      Body Electrical > Smart Key > Utility 

      Tester Display
      Configuration

   5. Perform the configuration according to the directions on the screen.
      NOTE:

      • When the configuration is performed, CAN communication between the engine stop and start ECU and control module connected to the CAN circuit is cut temporarily, and communication error DTCs may be detected. After performing the configuration, verify the DTCs for the control module connected to the CAN circuit and clear them if any are detected.
   6. Verify the DTCs for all of the control modules connected to the CAN circuit.
      • If any DTC is stored, clear it.
      • If the DTC is cleared, finish the procedure because the configuration has been completed normally.
      • If the DTC remains, perform troubleshooting according to the DTC.