DTC P0130-00: O2 Sensor Circuit (Bank 1 Sensor 1) [08/2018 - ]: Contents
| DTC No. |
Detection Item |
DTC Detection Condition |
Warning Indicate |
Memory |
Fail-safe Operation |
Note |
| P013000 |
O2 Sensor Circuit (Bank 1 Sensor 1) |
200 Pin Type
- Voltage problem between ECM terminal C27-81 and ECM terminal C27-82
186 Pin Type
- Voltage problem between ECM terminal C28-4 and ECM terminal C28-3
|
- Check engine light: ON
- Master warning light: OFF
- Charging system warning light: OFF
- Engine oil warning light: OFF
- Wrench warning indicator light: OFF
|
DTC stored |
Applicable |
- Drive cycle: 2
- Monitor item: A/F sensor, HO2S
- Self test type: CMDTC self test, KOER self test
|
DETAILS ON DTCS (200 PIN TYPE)
| DTC DETECTION CONDITION |
Voltage problem between ECM terminal C27-81 and ECM terminal C27-82 |
| Determination conditions |
- A condition in which the voltage between ECM terminals C27-81 and C27-82 exceeds the specified range continues for the specified period or more.
|
| Preconditions |
- Switch the ignition ON (engine off or on)
- Battery voltage: 11-18 V*1
- The following DTC is not detected:
- Internal ECM malfunction: P064D00
*1: Value can be verified by displaying PIDs using Techstream |
| Drive cycle |
|
| Self test type |
- CMDTC self test, KOER self test
|
| Sensor used |
|
| FAIL-SAFE OPERATION |
- Fixes duty value of A/F sensor heater
- Stops fuel feedback control of A/F sensor
|
| VEHICLE STATUS WHEN DTCS ARE OUTPUT |
- Illuminates check engine light.
|
| TROUBLE AREA |
- A/F sensor connector or terminals malfunction
- ECM connector or terminals malfunction
- Deterioration in wiring harness between the following terminals:
- A/F sensor terminal C6-6-ECM terminal C27-80
- A/F sensor terminal C6-5-ECM terminal C27-81
- A/F sensor terminal C6-4-ECM terminal C27-82
- A/F sensor malfunction
- ECM malfunction
|
DETAILS ON DTCS (186 PIN TYPE)
| DTC DETECTION CONDITION |
Voltage problem between ECM terminal C28-4 and ECM terminal C28-3 |
| Determination conditions |
- A condition in which the voltage between ECM terminals C28-4 and C28-3 exceeds the specified range continues for the specified period or more.
|
| Preconditions |
- Switch the ignition ON (engine off or on)
- Battery voltage: 11-18 V*1
- The following DTC is not detected:
- Internal ECM malfunction: P064D00
*1: Value can be verified by displaying PIDs using Techstream |
| Drive cycle |
|
| Self test type |
- CMDTC self test, KOER self test
|
| Sensor used |
|
| FAIL-SAFE OPERATION |
- Fixes duty value of A/F sensor heater
- Stops fuel feedback control of A/F sensor
|
| VEHICLE STATUS WHEN DTCS ARE OUTPUT |
- Illuminates check engine light.
|
| TROUBLE AREA |
- A/F sensor connector or terminals malfunction
- ECM connector or terminals malfunction
- Deterioration in wiring harness between the following terminals:
- A/F sensor terminal C35-6-ECM terminal C28-17
- A/F sensor terminal C35-5-ECM terminal C28-4
- A/F sensor terminal C35-4-ECM terminal C28-3
- A/F sensor malfunction
- ECM malfunction
|