DTC P061B-00: Internal Control Module Torque Calculation Performance [07/2015 - ]: Procedure
- VERIFY RELATED PENDING CODE AND/OR DTC
- Switch the ignition off, then ON (engine off).
- Perform the Pending Trouble Code Access Procedure and DTC Reading Procedure.
Refer to ON-BOARD DIAGNOSTIC TEST [07/2015 - ]
Powertrain > Engine > Trouble Codes
- Are any other PENDING CODEs and/or DTCs present?
Result
Result Yes No
Result:
Yes
GO TO THE APPLICABLE PENDING CODE OR DTC INSPECTION.
- Refer to DIAGNOSTIC TROUBLE CODE CHART [07/2015 - 08/2018] Refer to DIAGNOSTIC TROUBLE CODE CHART [08/2018 - 08/2019] Refer to DIAGNOSTIC TROUBLE CODE CHART [08/2019 - ]
Result:
No
See step 2
- INSPECT ECM CONNECTOR CONDITION
- Switch the ignition off.
- Disconnect the ECM connector.
- Inspect for poor connection (such as damaged/pulled-out pins, corrosion).
- Is there any malfunction?
Result
Result Yes No
Result:
Yes
See step 6
Result:
No
See step 3
- VERIFY DTC TROUBLESHOOTING COMPLETED
- Always reconnect all disconnected connectors.
- Clear the DTC from the ECM memory using the Techstream.
Refer to AFTER REPAIR PROCEDURE [07/2015 - ]
Powertrain > Engine > Clear DTCs
- Perform the KOEO or KOER self test.
Refer to ON-DEMAND SELF-TEST/KEY-ON ENGINE RUNNING SELF-TEST [07/2015 - ]
Powertrain > Engine > Utility
Tester Display Key-On Engine Running Self-Test Powertrain > Engine > Utility
Tester Display On-Demand Self-Test - Is the same DTC present?
Result
Result Yes No
Result:
Yes
See step 5
Result:
No
See step 4
- VERIFY AFTER REPAIR PROCEDURE
- Perform the "AFTER REPAIR PROCEDURE".
Refer to AFTER REPAIR PROCEDURE [07/2015 - ]
- Are any DTCs present?
Result
Result Yes No
Result:
No
DTC TROUBLESHOOTING COMPLETED.
Result:
Yes
GO TO THE APPLICABLE DTC INSPECTION.
- Perform the "AFTER REPAIR PROCEDURE".
- REPLACE THE ECM.
- Refer to REMOVAL [07/2015 - ]
- Then go to the next step.
Result
Proceed to NEXT
Result:
NEXT
See step 4
- REPAIR OR REPLACE THE CONNECTOR AND/OR TERMINALS.
Result:
NEXT
See step 3