DTC U2300-54: Central Configuration missing calibration; DTC U2300-55: Central Configuration not configured; DTC U2300-56: Central Configuration invalid / incompatible configuration [07/2015 - ]: Procedure

RECORD CONFIGURATION DATA

Switch the ignition OFF.
Switch the ignition ON (engine off or on), and maintain this condition for approx. 1 min.
Switch the ignition OFF, and maintain this condition for approx. 3 s.

Switch the ignition ON (engine off or on).

Result

Proceed to
NEXT

Result:

See step 2

VERIFY POWER STEERING ECU DTC

Clear the DTC.
Refer to DTC CHECK / CLEAR [07/2015 - 08/2019] , or refer to DTC CHECK / CLEAR [08/2019 - ]

Chassis > Electronic-Controlled Power Steering > Clear DTCs
Recheck for DTCs.
Refer to DTC CHECK / CLEAR [07/2015 - 08/2019] , or refer to DTC CHECK / CLEAR [08/2019 - ]

Chassis > Electronic-Controlled Power Steering > Trouble Codes

Is the same DTC present?

Result

Proceed to
Yes
No

Result:

Yes

See step 7

Result:

See step 5

VERIFY COMBINATION METER DTC

Recheck for DTCs.
Refer to DTC CHECK / CLEAR [07/2015 - 08/2019] , or refer to DTC CHECK / CLEAR [08/2019 - ]

Body Electrical > Combination Meter > Trouble Codes

Are any DTCs present?

Result

Proceed to
Yes
No

Result:

Yes

GO TO APPLICABLE DTC INSPECTION.

Refer to DIAGNOSTIC TROUBLE CODE CHART [07/2015 - 08/2019] , or refer to DIAGNOSTIC TROUBLE CODE CHART [08/2019 - ]
Repair the combination meter, then perform the configuration for the combination meter.
1. Refer to DISASSEMBLY [07/2015 - ]
2. Refer to INSPECTION [07/2015 - ]

Result:

See step 4

VERIFY POWER STEERING ECU DTC

Clear the DTC.
Refer to DTC CHECK / CLEAR [07/2015 - 08/2019] , or refer to DTC CHECK / CLEAR [08/2019 - ]

Chassis > Electronic-Controlled Power Steering > Clear DTCs
Recheck for DTCs.
Refer to DTC CHECK / CLEAR [07/2015 - 08/2019] , or refer to DTC CHECK / CLEAR [08/2019 - ]

Chassis > Electronic-Controlled Power Steering > Trouble Codes

Is the same DTC present?

Result

Proceed to
Yes
No

Result:

Yes

See step 6

Result:

See step 5

VERIFY NO DTC IS PRESENT

Are any DTCs present?

Result

Proceed to
Yes
No

Result:

DTC TROUBLESHOOTING COMPLETED.

Result:

Yes

GO TO APPLICABLE DTC INSPECTION.. Refer to DIAGNOSTIC TROUBLE CODE CHART [07/2015 - 08/2019] , or refer to DIAGNOSTIC TROUBLE CODE CHART [08/2019 - ]

REPEAT THE INSPECTION FROM STEP 1.

If the malfunction recurs, replace the steering column, then go to the next step.

Refer to REMOVAL [07/2015 - 08/2018] , or refer to REMOVAL [08/2018 - 08/2019] , or refer to REMOVAL [08/2019 - ]

Result

Proceed to
NEXT

Result:

See step 5

REPEAT THE INSPECTION FROM STEP 1.

If the malfunction recurs, go to the next step.

Result

Proceed to
NEXT

Result:

See step 3