DTC U3000-05: Control Module System Programming Failures; DTC U3000-41: Control Module general checksum failure; DTC U3000-43: Control Module special memory failure; DTC U3000-46: Control Module calibration / parameter memory failure; DTC U3000-49: Control Module internal electronic failure; DTC U3000-61: Control Module signal calculation failure; DTC U3000-96: Control Module component internal failure [07/2015 - ]: Procedure

1. Clear the DTC.

   Refer to DTC CHECK / CLEAR [07/2015 - 08/2019] , or refer to DTC CHECK / CLEAR [08/2019 - ]

   Chassis > Electronic-Controlled Power Steering > Clear DTCs 

2. Recheck for DTCs.

   Refer to DTC CHECK / CLEAR [07/2015 - 08/2019] , or refer to DTC CHECK / CLEAR [08/2019 - ]

   Chassis > Electronic-Controlled Power Steering > Trouble Codes 

3. Is the same DTC present?

   Result

   Proceed to
   Yes
   No

Result: 

Yes 

REPLACE THE STEERING COLUMN.. Refer to  REMOVAL [07/2015 - 08/2018]  , or refer to  REMOVAL [08/2018 - 08/2019]  , or refer to  REMOVAL [08/2019 - ] 

Result: 

No 

See step  2

1. Are any DTCs present?

   Result

   Proceed to
   Yes
   No

Result: 

No 

DTC TROUBLESHOOTING COMPLETED. 

Result: 

Yes 

GO TO APPLICABLE DTC INSPECTION.. Refer to  DIAGNOSTIC TROUBLE CODE CHART [07/2015 - 08/2019]  , or refer to  DIAGNOSTIC TROUBLE CODE CHART [08/2019 - ]