Installation [06/2016 - ]: Procedure

INSTALL ECM BRACKET
1. Engage the 2 claws to install a new ECM bracket to the ECM.
  NOTE:
  - After attaching the ECM bracket to the ECM, do not remove the ECM bracket.
  - If the ECM bracket is attached to the ECM in the incorrect direction, replace the ECM bracket with a new one.
INSTALL ECM
NOTE:
When replacing the ECM, do not use ECM with different specifications.
1. Install the ECM with the 2 nuts.
  Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf)
2. Connect the 4 connectors to the ECM.
  NOTE:
  Be sure to securely connect the connectors.
INSTALL CONTROL UNIT RELAY ASSEMBLY
Refer to PROCEDURE - Step 1
INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY
Refer to PROCEDURE - Step 3 [06/2016 - 03/2017] , or refer to PROCEDURE - Step 3 [03/2017 - ]
INSTALL INSTRUMENT SIDE PANEL RH
Refer to PROCEDURE - Step 7 [06/2016 - 03/2017] , or refer to PROCEDURE - Step 7 [03/2017 - ]
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 6.0 N*m (61 kgf*cm, 53 in.*lbf)
PERFORM INITIALIZATION
See step 6