LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2020 >> Highlander LE, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 104 (Dynamic Torque Control AWD System - Diagnostics - Introduction) >> Dynamic Torque Control AWD System >> DTC Check / Clear [12/2019 - ] >> DTC Check / Clear [12/2019 - ]
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Check / Clear [12/2019 - ]

WARNING: This page is about a different variant/trim than selected.
  1. DTC CHECK 
    1. Check for DTC(s).

      Chassis > Four Wheel Drive > Trouble Codes 

    2. Check the details of the DTCs.
      NOTE:

      Make sure to clear the DTCs after repair.

      HINT: 

      Display Item Description
      Test Failed Shows the malfunction judgment results during the current trip.
      Confirmed Shows the DTCs confirmed up to now (The number of current trips differs for each DTC.)
    3. Check the freeze frame data.
      1. If a DTC is stored, check the corresponding freeze frame data to gain an understanding of the vehicle condition at the time.

        Refer to FREEZE FRAME DATA [12/2019 - ] 

  2. CHECK TIME STAMP 

    HINT: 

    By checking Time Stamp, the time and order in which DTCs were stored in an ECU can be checked.

    1. Enter the following menus: Health Check.
    2. Perform the following steps when the data setting screen is displayed.
    3. Select the systems for which to perform Health Check and check for time stamp data.

      Selectable items: 

      • Powertrain
      • Chassis
      • Body
      • Store All Data
    4. Select "Yes" when "Would you like to include Time Stamp Data?" is displayed.

      HINT: 

      If "Yes" is not selected, time stamp data will not be stored.

    5. After Health Check has completed, select "Time Stamp Data" to display the Time Stamp screen.
    6. Select the desired system from the drop-down list on the bottom of the Time Stamp screen.
    7. Check the order and time which DTCs were stored for the selected system.
  3. DTC CLEAR 
    1. Operate the GTS to clear the codes.

      Chassis > Four Wheel Drive > Clear DTCs 

    2. Press the DTC clear button.
      NOTE:

      When DTCs are cleared, all data related to the DTCs is also cleared.

      HINT: 

      If the malfunction continues, the DTCs will be stored again when the detection conditions are met.