LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2020 >> Prius XLE AWD-e >> Repair and Diagnosis (Single Page) >> Restraints >> Air Bag, SRS >> Occupant Classification System - Diagnostics - Introduction >> Occupant Classification System >> Data List / Active Test [11/2015 - ] >> Data List / Active Test [11/2015 - ]
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Data List / Active Test [11/2015 - ]

  1. DATA LIST 

    HINT: 

    Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    NOTE:

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    1. Turn the power switch off.
    2. Connect the Techstream to the DLC3.
    3. Turn the power switch on (IG).
    4. Turn the Techstream on.
    5. Enter the following menus: Body Electrical / Occupant Detection / Data List.
    6. Read the Data List according to the display on the Techstream.

      Body Electrical > Occupant Detection > Data List 

      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      FL Sensor Weight Information Front left sensor weight information Min.: -75.852 kg (-167.224 lb)
      Max.: 104.737 kg (230.903 lb)      		 Current value displayed -
      RL Sensor Weight Information Rear left sensor weight information Min.: -75.852 kg (-167.224 lb)
      Max.: 104.737 kg (230.903 lb)      		 Current value displayed -
      Total Weight Information Total weight information Min.: -151.704 kg (-334.447 lb)
      Max.: 209.475 kg (461.808 lb)      		 Current value displayed -
      Weight Forward and Rearward Difference Weight difference between front and rear Min.: -180.589 kg (-398.127 lb)
      Max.: 180.589 kg (398.126 lb)      		 Current value displayed -
      Airbag Total Weight Total weight information for airbag system Min.: -161.595 kg (-356.253 lb)
      Max.: 226.017 kg (498.277 lb)      		 Current value displayed -
      Belt Warning Total Weight Total weight information for seat belt warning system Min.: -155.001 kg (-341.716 lb)
      Max.: 219.400 kg (483.689 lb)      		 Current value displayed -
      VSC Status Vehicle speed status ON or OFF ON: Vehicle speed valid -
      VSC Vehicle Speed Vehicle speed Min.: 0.00 km/h (0.00 mph)
      Max.: 327.67 km/h (203.61 mph)      		 Current value displayed -
      VSC Zero Point1 Zero point for acceleration sensor 1 Min.: -4.5952 m/s2
      Max.: 4.5593 m/s2      		 Current value displayed -
      VSC Zero Point2 Zero point for acceleration sensor 2 Min.: -4.5952 m/s2
      Max.: 4.5593 m/s2      		 Current value displayed -
      VSC Calibration Status Vehicle stability control calibration status Calibrated or Uncalibrated Calibrated -
      VSC Assembly Information Acceleration sensor assembly information Reverse Position or Normal Position Reverse Position or Normal Position Displays a fixed value for each vehicle.
      Yaw Rate/G Sensor Voltage Invalid Flag Yaw rate and acceleration sensor voltage invalid flag ON or OFF ON: Valid -
      Yaw Rate/G Sensor Malfunction Flag1 Malfunction flag for acceleration sensor 1 OK or NG OK -
      Yaw Rate/G Sensor Invalid Flag1 Invalid flag for acceleration sensor 1 ON or OFF ON: Valid -
      Yaw Rate/G Sensor Malfunction Flag2 Malfunction flag for acceleration sensor 2 OK or NG OK -
      Yaw Rate/G Sensor Invalid Flag2 Invalid flag for acceleration sensor 2 ON or OFF ON: Valid -
      Yaw Rate/G Sensor Assembly Information Acceleration sensor assembly information for occupant classification system Unset, Reverse Position or Normal Position Reverse Position or Normal Position
      • Displays a fixed value for each vehicle.
      • "Unset" will be displayed for approximately 2 seconds after the power switch is turned on (IG).
      Passenger Detection (Airbag) Passenger classification OFF/Child, CRS1, CRS2, AF05 or AM50 OFF/Child: Vacant or child is seated
      CRS1: Child restraint system is installed
      CRS2: Child restraint system is installed
      AF05: Adult is seated
      AM50: Adult is seated      		 -
      Passenger Detection (Belt Warning) Passenger detection for seat belt warning system OFF, Baggage or ON OFF: Seat is vacant
      Baggage: Seat is occupied by baggage
      ON: Seat is occupied      		 -
      Driving Status Driving status Stop, Drive or Turn Stop: Vehicle is stopped
      Drive: Vehicle is being driven straight
      Turn: Vehicle is turning      		 -
      Passenger Buckle SW Passenger side buckle switch NG, Set or Unset Set: Front passenger seat belt is fastened
      Unset: Front passenger seat belt is not fastened      		 "NG" will be displayed immediately after the power switch is turned on.
      The Number of DTCs Number of DTC recorded Min.: 0, Max.: 255 0 The number displayed is the total current DTCs and history DTCs stored (excluding duplicates).
scientia non olet · About LEMON Manuals