LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2020 >> RAV4 LE, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Engine Control System (A25A-FXS) (W/O Canister Pump Module) - Diagnostics - Introduction) >> SFI SYSTEM (w/o Canister Pump Module) >> Basic Inspection [11/2018 - 08/2020] >> Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Basic Inspection [11/2018 - 08/2020]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. CHECK AUXILIARY BATTERY VOLTAGE 
    NOTE:

    Carry out this check with the engine stopped and the power switch off.

    Result

    Result Proceed to
    11 V or higher OK
    Below 11 V NG

    Result: 

    NG 

    CHARGE OR REPLACE AUXILIARY BATTERY 

    Result: 

    OK 

    See step  2

  2. CHECK WHETHER ENGINE CRANKS 

    Result

    Proceed to
    OK
    NG

    Result: 

    NG 

    PROCEED TO PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [11/2018 - 08/2020]  

    Result: 

    OK 

    See step  3

  3. CHECK WHETHER ENGINE STARTS 

    Result

    Proceed to
    OK
    NG

    Result: 

    NG 

    See step  6

    Result: 

    OK 

    See step  4

  4. CHECK AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY 
    1. Visually check that the air cleaner filter element sub-assembly is not excessively contaminated with dirt or oil.

      Result

      Proceed to
      OK
      NG

    Result: 

    NG 

    REPLACE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY 

    Result: 

    OK 

    See step  5

  5. CHECK IDLE SPEED 
    1. Check the engine idle speed.

      Refer to PROCEDURE - Step 8 [11/2018 - 02/2019] , or refer to PROCEDURE - Step 8 [02/2019 - 08/2020]

      Result

      Proceed to
      OK
      NG

    Result: 

    NG 

    PROCEED TO AND CONTINUE TO TROUBLESHOOT 

    Result: 

    OK 

    See step  6

  6. CHECK FUEL PRESSURE 
    1. Check the fuel pressure.

      Refer to PROCEDURE - Step 2 [11/2018 - 02/2019] , or refer to PROCEDURE - Step 2 [02/2019 - ]

      Result

      Proceed to
      OK
      NG

    Result: 

    NG 

    PROCEED TO AND CONTINUE TO TROUBLESHOOT 

    Result: 

    OK 

    See step  7

  7. CHECK FOR SPARK 
    1. Perform a spark test.

      Refer to PROCEDURE - Step 2 [11/2018 - 02/2019] , or refer to PROCEDURE - Step 2 [02/2019 - 08/2020]

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    PROCEED TO PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [11/2018 - 08/2020]  

    Result: 

    NG 

    PROCEED TO AND CONTINUE TO TROUBLESHOOT 

scientia non olet · About LEMON Manuals