LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2020 >> Sequoia TRD Pro >> Repair and Diagnosis (Single Page) >> General Information >> Reset Procedures >> Tire Pressure Monitor Systems >> TPMS Reset Procedures >> Tire Pressure Sensor Registration >> Registration Using Scan Tool
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Registration Using Scan Tool

  1. Set the tire pressure of all wheels to pressure specified on the tire and loading information label.
  2. With the ignition switch OFF, connect the Techstream to the DLC3.
  3. Turn the ignition switch to ON position.
  4. Enter the following menus: Chassis / Tire Pressure Monitor / Utility / ID Registration.
    NOTE: On later models, Tire Number Registration is the last menu, after ID Registration.
  5. Perform the procedures displayed on the Techstream.
    NOTE: If this step is not completed within 300 seconds, Registration mode will be canceled.
  6. Confirmation of transmitter ID registration:
    1. Enter the Techstream menu items in this order: Chassis / Tire Pressure Monitor / Data List.
    2. Confirm that the expected tire pressures of all tires are displayed on the screen.
    NOTE: It may take up to about 5 to 6 minutes to update the tire pressure data. If the values are not displayed after several minutes, perform troubleshooting according to the inspection procedure for DTCs C2121/21 to C2124/24. If the IDs have not been registered, DTC C2171/71 is set after 3 minutes or more.
scientia non olet · About LEMON Manuals