Installation [11/2017 - 09/2019]: Procedure

INSTALL NO. 2 ECM BRACKET
1. Install the No. 2 ECM bracket to the ECM with the 2 screws.
  Torque: 3.2 N*m (33 kgf*cm, 28 in.*lbf)
INSTALL ECM BRACKET
1. Install the ECM bracket to the ECM with the 2 screws.
  Torque: 3.2 N*m (33 kgf*cm, 28 in.*lbf)
INSTALL ECM
1. Install the ECM to the instrument panel reinforcement assembly with the 2 bolts and nut.
  Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
2. Connect the 6 connectors.
3. Engage the clamp to install the wire harness.
INSTALL LOWER INSTRUMENT PANEL ASSEMBLY
Refer to PROCEDURE - Step 4
INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY
Refer to PROCEDURE - Step 1
INSTALL GLOVE COMPARTMENT PLATE
Refer to PROCEDURE - Step 6
INSTALL INSTRUMENT SIDE PANEL RH
Refer to PROCEDURE - Step 7
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)

NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [11/2017 - 09/2019]
PERFORM SRS WARNING LIGHT
(Refer to DIAGNOSIS SYSTEM [08/2015 - 09/2019] )
PERFORM INITIALIZATION
Refer to INITIALIZATION [11/2017 - 09/2019]