DTC U0100: Lost Communication with ECM / PCM "A"; DTC U0104: Lost Communication with Cruise Control Module; DTC U0122: Lost Communication with Vehicle Dynamics Control Module; DTC U0125: Lost Communication with Yaw Rate Sensor Module; DTC U0126: Lost Communication with Steering Angle Sensor Module; DTC U0129: Lost Communication with Brake System Control Module [08/2019 - ]: Procedure

1. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [08/2019 - ]

2. Make sure that the DTC detection conditions are met.

   HINT: 

   If the detection conditions are not met, the system cannot detect the malfunction.

   1. Turn the ignition switch to ON.
   2. Turn the dynamic radar cruise control system on using the cruise control main switch (ON-OFF button).
   3. Drive the vehicle at 36 km/h (22 mph) or more for 5 seconds or more.
3. Check for DTCs.

   Refer to DTC CHECK / CLEAR [08/2019 - ]

   Result

   Result	Proceed to
   DTC U0100, U0104, U0122, U0125, U0126 and U0129 are not output	A
   DTC U0100, U0104, U0122, U0125, U0126 or U0129 is output	B

Result: 

A 

USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [08/2019 - ] 

Result: 

B 

GO TO CAN COMMUNICATION SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [08/2019 - ]