DTC B1787: Rear Occupant Classification Sensor LH Collision Detection [08/2013 - ]: Description
WARNING: This page is about a different car, the 2018 Toyota Corolla, 2017 Toyota Corolla, 2016 Toyota Corolla, 2015 Toyota Corolla, and 2014 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
DTC B1787 is stored when the occupant detection ECU receives a collision detection signal sent by the rear occupant classification sensor LH if an accident occurs.
DTC B1787 is also stored when the front seat assembly RH is subjected to a strong impact, even if an actual accident did not occur.
If the vehicle was not in a collision, but the occupant detection ECU receives a collision detection signal and stores DTC B1787, the DTC can be cleared by performing Zero Point Calibration and Sensitivity Check.
Therefore, if DTC B1787 is output, first perform Zero Point Calibration and Sensitivity Check.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B1787 | Rear Occupant Classification Sensor LH Collision Detection | for TMMMS Made:
for TMMC Made:
|
for TMMMS Made:
for TMMC Made:
|
- *: The rear occupant classification sensor LH is built into the separate type front seat cushion spring assembly RH or front seat adjuster sub-assembly RH.