How To Proceed With Troubleshooting [11/2022 - ]: Procedure

Result

Result: 

NEXT 

See step  2

HINT: 

• In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
• Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.
• The following 5 items are important points for problem analysis:

Result

Result: 

NEXT 

See step  3

1. Measure the auxiliary battery voltage with the ignition switch off.

   Standard Voltage

   11 to 14 V

   If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding to the next step.

2. Check the fuses and relays.
3. Check the connector connections and terminals to make sure that there are no abnormalities such as loose connections, deformation, etc.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  4

1. Using the GTS, check for CAN communication system DTCs.

   for HV Model: Refer to DIAGNOSIS SYSTEM [11/2022 - ]

   for Gasoline Model: Refer to DIAGNOSIS SYSTEM [11/2022 - 03/2023] , or refer to DIAGNOSIS SYSTEM [03/2023 - 08/2023] , or refer to DIAGNOSIS SYSTEM [08/2023 - 09/2024] , or refer to DIAGNOSIS SYSTEM [09/2024 - ]

   Result

   Result	Proceed to
   CAN DTCs are not output	A
   CAN DTCs are output	B

Result: 

B 

GO TO CAN COMMUNICATION SYSTEM 

for HV Model: Refer to HOW TO PROCEED WITH TROUBLESHOOTING [09/2022 - ]

for Gasoline Model: Refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2022 - 08/2023] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2023 - 09/2024] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [09/2024 - ]

Result: 

A 

See step  5

1. Using the GTS, check for LIN communication system DTCs.

   Body Electrical > Main Body > Trouble Codes 

   Body Electrical > Power Source Control > Trouble Codes 

   Body Electrical > Smart Key > Trouble Codes 

   Result

   Result	Proceed to
   LIN DTCs are not output	A
   LIN DTCs are output	B

Result: 

B 

GO TO DIAGNOSTIC TROUBLE CODE CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [11/2022 - ]  

Result: 

A 

See step  6

1. Terminals of ECU

   Refer to TERMINALS OF ECU [11/2022 - ] 

2. Data List / Active Test

   Refer to DATA LIST / ACTIVE TEST [11/2022 - ] 

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  7

Result

Result: 

NEXT 

See step  8

Result

Result: 

NEXT 

END