Service Data [08/2013 - ]
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2019 Toyota Corolla, 2018 Toyota Corolla, 2017 Toyota Corolla, 2016 Toyota Corolla, and 2015 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
| Starter assembly | Standard current | Below 90 A at 11.5 V |
| Starter armature assembly standard resistance | Segment - Segment | Below 1 Ω |
| Commutator - Armature coil core | 10 kΩ or higher | |
| Starter armature assembly commutator runout | Standard runout | 0.02 mm (0.000787 in.) |
| Maximum runout | 0.04 mm (0.00157 in.) | |
| Starter armature assembly commutator diameter | Standard diameter | 29.9 mm (1.18 in.) |
| Minimum diameter | 28.8 mm (1.13 in.) | |
| Starter armature assembly undercut depth | Standard depth | 0.9 mm (0.0354 in.) |
| Minimum depth | 0.4 mm (0.0157 in.) | |
| Brush length | Standard length | 10.5 mm (0.413 in.) |
| Minimum length | 7.0 mm (0.276 in.) | |
| Starter brush holder assembly standard resistance | A - B | 10 kΩ or higher |
| A - C | ||
| A - D | Below 1 Ω | |
| B - C | ||
| B - D | 10 kΩ or higher | |
| C - D | ||
| Magnet starter switch assembly standard resistance | Terminal 50 - Terminal C | Below 1 Ω |
| Terminal 50 - Switch body | Below 1.5 Ω | |
| Engine switch | Standard resistance 5(SS1) - 6(AGND) (Not pushed) 1(SS2) - 6(AGND) (Not pushed) |
10 kΩ or higher |
| Standard resistance 5(SS1) - 6(AGND) (Pushed) 1(SS2) - 6(AGND) (Pushed) |
Below 1 Ω | |
| Ignition switch | Standard resistance Between all terminals (LOCK) |
10 kΩ or higher |
| Standard resistance 5 (AM1) - 7 (ACC) (ACC) |
Below 1 Ω | |
| Standard resistance 5 (AM1) - 7 (ACC) - 8 (IG1) (ON) |
||
| Standard resistance 3 (IG2) - 4 (AM2) (ON) |
||
| Standard resistance 5 (AM1) - 6 (ST1) - 8 (IG1) (START) |
||
| Standard resistance 2 (ST2) - 3 (IG2) - 4 (AM2) (START) |
||
| Starter relay | Standard resistance 3 - 5 |
10 kΩ or higher (Battery voltage not applied) |
| Below 1 Ω (Battery voltage applied to terminals 1 and 2) |