LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2021 >> Corolla XLE >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Brake Control / Dynamic Control Systems (Service Information) (Model Code: ZRE172)) >> VSC Off Switch >> Inspection [08/2013 - ] >> Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Inspection [08/2013 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2019 Toyota Corolla, 2018 Toyota Corolla, 2017 Toyota Corolla, 2016 Toyota Corolla, and 2015 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT VSC OFF SWITCH 
    1. Make sure that there is no looseness in the locking part and the connecting part of the connector.
      GTY452289Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (VSC OFF Switch)
    2. Disconnect the VSC OFF switch connector.
    3. Check both the connector case and the terminal for deformation and corrosion.

      OK

      No deformation or corrosion.

    4. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      6 (+) - 3 (E) Switch pushed Below 1 Ω
      6 (+) - 3 (E) Switch not pushed 10 kΩ or higher

      If the result is not as specified, replace the VSC OFF switch.

scientia non olet · About LEMON Manuals