DTC B1795: Occupant Classification ECU Malfunction [08/2015 - ]: Procedure

CHECK FOR DTC
1. Turn the engine switch on (IG).
2. Clear the DTCs stored in the occupant classification ECU (Refer to DTC CHECK / CLEAR [08/2015 - ] ).
3. Clear the DTCs stored in the center airbag sensor (Refer to DTC CHECK / CLEAR [08/2015 - ] ).
4. Turn the engine switch off.
5. Turn the engine switch on (IG), and wait for at least 10 seconds.
6. Check for DTCs (Refer to DTC CHECK / CLEAR [08/2015 - ] ).
  OK
  
  DTC B1795 is not output.
  
  HINT:
  
  Codes other than DTC B1795 may be output at this time, but they are not related to this check.
Result:

OK

USE SIMULATION METHOD TO CHECK

(Refer to DIAGNOSIS SYSTEM [08/2015 - ] )

Result:

NG

See step 2
REPLACE NO. 1 SEAT CUSHION ASSEMBLY (OCCUPANT CLASSIFICATION ECU)
1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Using the Techstream, save the ECU data from the ECU which is installed in the vehicle (Refer to REGISTRATION [08/2015 - ] ).
4. Turn the engine switch off.
5. Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
6. Replace the No. 1 seat cushion (occupant classification ECU) (Refer to REMOVAL [08/2015 - ] ).
7. Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
8. Turn the engine switch on (IG).
9. Using the Techstream, load the previous ECU data stored in the Techstream into the new ECU (Refer to REGISTRATION [08/2015 - ] ).
10. Turn the engine switch off.
11. Turn the engine switch on (IG).
12. Clear the DTCs stored in the memory (Refer to DTC CHECK / CLEAR [08/2015 - ] ).
  HINT:
  
  If DTCs are not cleared at this time, past DTCs will remain.
Result:

NEXT

See step 3
PERFORM ZERO POINT CALIBRATION
1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Using the Techstream, perform zero point calibration (Refer to INITIALIZATION [08/2015 - ] ).
4. Turn the engine switch off.
5. Turn the engine switch on (IG).
6. Clear the DTCs stored in the occupant classification ECU (Refer to DTC CHECK / CLEAR [08/2015 - ] ).
  HINT:
  
  If the DTCs are not cleared at this time, past DTCs will remain.
Result:

NEXT

See step 4
PERFORM SENSITIVITY CHECK
1. Perform the sensitivity check (Refer to INITIALIZATION [08/2015 - ] ).
Result:

NEXT

END