How To Proceed With Troubleshooting [08/2015 - ]: Procedure

Result

Result: 

NEXT 

See step  2

Standard voltage

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding.

Result

Result: 

NEXT 

See step  3

1. Using the Techstream, check if the CAN communication system is functioning normally.

   See DIAGNOSIS SYSTEM [08/2015 - 08/2017] , or see DIAGNOSIS SYSTEM [08/2017 - 08/2019] , or see DIAGNOSIS SYSTEM [08/2019 - ]

   Result

   Result	Proceed to
   CAN DTCs are not output	A
   CAN DTCs are output	B

Result: 

B 

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING). See  HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - ] 

Result: 

A 

See step  4

1. Check for DTCs.

   See DTC CHECK / CLEAR [08/2015 - ] 

2. Clear the DTCs.

   See DTC CHECK / CLEAR [08/2015 - ] 

3. Recheck for DTCs.

   See DTC CHECK / CLEAR [08/2015 - ] 

   1. Simulate the malfunction and check if the DTCs are output again.

      See DTC CHECK / CLEAR [08/2015 - ] 

   Result

   Result	Proceed to
   DTCs are output	A
   DTCs are not output	B
   DTCs are not output, and the malfunction cannot be simulated or checked.	C

Result: 

B 

See step  9

Result: 

C 

SYMPTOM SIMULATION 

Result: 

A 

See step  5

Result

Result: 

NEXT 

See step  6

Result

Result: 

NEXT 

See step  7

Result

Result: 

NEXT 

See step  8

Result

Result: 

NEXT 

END 

Result

Result: 

NEXT 

See step  10

Result

Result: 

NEXT 

See step  11

Result

Result: 

NEXT 

END