Installation [08/2015 - ]: Procedure

1. Align the 2 pins and 2 guides, and engage the 6 claws to install the steering sensor to the spiral cable subassembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Guide
   *b	Pin
   *c	Lock Pin

   NOTE:

   • Do not remove the lock pin before the steering sensor is installed to the spiral cable subassembly.
   • Do not damage the pins of the spiral cable subassembly and guides of the steering sensor.
   • The spiral cable subassembly can be rotated up to 30° even when the interlock is engaged. Therefore, make sure that both guides are aligned properly when installing the steering sensor to the spiral cable subassembly.
2. Remove the lock pin from the steering sensor.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Refer to INSTALLATION [08/2015 - ]

Refer to INITIALIZATION [08/2015 - ]

Refer to CALIBRATION [08/2015 - ]