TPMS Reset Procedures: Notes

NOTE: The system will need to be initialized when tire pressures are adjusted, tires are rotated; tires are replaced with tires of different pressures; tire pressure sensor and/or tire pressure monitor ECU are replaced. See INITIALIZING TIRE PRESSURE MONITOR SYSTEM . When a tire pressure sensor and/or tire pressure monitor ECU are replaced, the sensor ID must be memorized (registered) by the tire pressure monitor ECU prior to system initialization. See TIRE PRESSURE SENSOR REGISTRATION .

NOTE: If negative battery terminal is disconnected, initialize the following systems after the cable is reconnected: variable gear ratio steering and moon roof. Refer to owner's manual or appropriate manufacturer service information.

If tire pressures are adjusted, initialize TPMS. With ignition ON, press and hold the tire pressure warning reset switch until the tire pressure warning light blinks slowly three times and the message "TIRE PRESSURE RESET PROCEEDING" appears on the multi-information display. Wait a few minutes, then turn ignition OFF.