Operation Check [11/2015 - ]

1. Continuously apply water to the windshield glass in front of the rain sensor.
2. Turn the power switch on (IG).
3. Move the windshield wiper switch assembly to the AUTO position.
4. Check that the wipers move.

HINT: 

When the AUTO wiper function is set to off using the customize function, intermittent control operates.

1. Turn the power switch on (IG).
2. Move the windshield wiper switch assembly to the INT*1 or AUTO*2 position.
3. Check that the wipers move intermittently.

1. Turn the power switch on (IG).
2. Operate the washer switch (front) for approximately 0.5 seconds or more and confirm that the front wipers operate in the LO setting when the washer fluid is sprayed and that the front wipers cycle 3 times after releasing the washer switch (front).

1. Turn the power switch on (IG).
2. While the windshield wiper switch assembly (rear wiper control switch) to is set to OFF, operate the washer switch (rear) for approximately 0.5 seconds or more and check that the rear wiper operates when the washer fluid is sprayed.
3. Check that the rear wiper operates for approximately 2.5 seconds after releasing the washer switch (rear).

1. Turn the power switch on (IG).
2. At a vehicle speed of approximately less than 4 km/h (2 mph), check that the front wipers operate for 1 cycle approximately 3 seconds after washer cooperation completes.