Installation [11/2015 - ]: Procedure

INSTALL SPARK PLUG
HINT:

Perform "Inspection After Repair" after replacing a spark plug.

Refer to INITIALIZATION [11/2015 - ]
1. Install the 4 spark plugs to the cylinder head sub-assembly.
  Torque: 20 N.m (204 kgf.cm, 15 ft./lbf)
  
  NOTE:
  If a spark plug has been struck or dropped, replace it.
  
  HINT:
  
  Install the same parts to their original positions.
INSTALL IGNITION COIL ASSEMBLY
HINT:

Perform "Inspection After Repair" after replacing an ignition coil assembly.

Refer to INITIALIZATION [11/2015 - ]
1. Install the 4 ignition coil assemblies to the cylinder head cover sub-assembly with the 4 bolts.
  Torque: 10 N.m (102 kgf.cm, 7 ft./lbf)
  
  NOTE:
  If an ignition coil assembly has been struck or dropped, replace it.
  
  HINT:
  
  Install the same parts to their original positions.
2. Connect the 4 ignition coil assembly connectors.
INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 3
INSTALL COWL WATER EXTRACT SHIELD LH
Refer to PROCEDURE - Step 4
INSTALL COWL WATER EXTRACT SHIELD RH
Refer to PROCEDURE - Step 5
INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH
Refer to PROCEDURE - Step 6
INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH
Refer to PROCEDURE - Step 7
INSTALL FRONT WIPER ARM HEAD CAP
Refer to PROCEDURE - Step 8
INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 72 [11/2015 - 08/2016] , or refer to PROCEDURE - Step 72 [08/2016 - 12/2018] , or refer to PROCEDURE - Step 72 [12/2018 - 07/2020] , or refer to PROCEDURE - Step 72 [07/2020 - ]
PERFORM INITIALIZATION
1. Perform "Inspection After Repair" after replacing an ignition coil assembly and spark plug.
  Refer to INITIALIZATION [11/2015 - ]