Inspection [11/2015 - ]: Procedure
- INSPECT THROTTLE BODY ASSEMBLY
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Throttle Body Assembly)Standard Resistance
Click Location & Routing(C4)
Click Connector(C4)
Tester Connection Condition Specified Condition C4-1 (M-) - C4-2 (M+) 20 °C (68 °F) 0.3 to 100 Ω If the result is not as specified, replace the throttle body assembly.
- Measure the resistance according to the value(s) in the table below.