Installation [08/2020 -]: Procedure

WARNING: This page is about a different car, the 2021 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL TRANSFER ASSEMBLY

Using SST and a 17 mm union nut wrench, install the transfer assembly to the automatic transaxle assembly with the 8 nuts.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	17 mm Union Nut Wrench
*b	Torque Wrench Fulcrum Length

SST: 09961-00950

Specified tightening torque

Torque: 68.6 N*m (700 kgf*cm, 51 ft.*lbf)

HINT:

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Refer to PRECAUTION [04/2018 -]
When using a 17 mm union nut wrench (fulcrum length of 30 mm (1.18 in.)) + SST (fulcrum length of 150 mm (5.91 in.)) + torque wrench (fulcrum length of 255 mm (10.0 in.)): 40.2 N*m (410 kgf*cm, 30 ft.*lbf)

INSTALL REAR ENGINE MOUNTING BRACKET SUB-ASSEMBLY
Refer to PROCEDURE - Step 13
INSTALL NO. 1 PROPELLER SHAFT HEAT INSULATOR BRACKET SUB-ASSEMBLY
1. Install the No. 1 propeller shaft heat insulator bracket sub-assembly to the transfer assembly with the 2 bolts.
  Torque: 25 N*m (255 kgf*cm, 18 ft.*lbf)
INSTALL PROPELLER SHAFT HEAT INSULATOR
Refer to PROCEDURE - Step 14
INSTALL AUTOMATIC TRANSAXLE ASSEMBLY
Refer to INSTALLATION [08/2020 -]