LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2021 >> RAV4 Adventure >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Smart Key System (For Entry, Except HV) - Symptom Tests (2 Of 2) >> SMART KEY SYSTEM (for Entry Function, Gasoline Model) >> Entry Unlock and Unlatch Functions do not Operate Using Kick Sensor [10/2023 - ] >> Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Entry Unlock and Unlatch Functions do not Operate Using Kick Sensor [10/2023 - ]: Procedure

  1. CHECK CUSTOMIZE SETTING 
    1. Turn the engine switch on (IG).
    2. Enter the following menus: [Settings] → [Vehicle customize] → [Door control]
    3. Select the setting by referring to the table below.
      Display Description Default Setting Relevant ECU
      Hands Free Function that can be used to set the hands free power back door. ON ON or OFF Main body ECU (multiplex network body ECU)

      Result

      Result Proceed to
      The customize setting is "ON" A
      The customize setting is "OFF" B

    Result: 

    PERFORM CUSTOMIZE SETTING. Refer to  CUSTOMIZE PARAMETERS [10/2023 - ] 

    Result: 

    See step  2

  2. CHECK OPERATION HISTORY 
    1. Enter the following menus: Body Electrical / Smart Key / Utility / Operation History.

      Body Electrical > Smart Key > Utility 

      Tester Display
      Operation History
      AUTO ENTRY WIRELESS OPERATION HISTORY

      Parameter Name Content
      Kick Sensor Open Request Signal. The multiplex network door ECU receives kick detection signals from the kick door control sensor and sends certification requests to the certification ECU (smart key ECU assembly). If certification is OK, an open permission is sent to the multiplex network door ECU.

      Result

      Result Proceed to
      Not output A
      "Kick Sensor Open Request Signal" is output B

    Result: 

    GO TO POWER BACK DOOR SYSTEM (Power Back Door cannot be Operated Using Kick Sensor). Refer to  Power Back Door cannot be Operated Using Kick Sensor [10/2023 - ] 

    Result: 

    See step  3

  3. CHECK ENTRY LOCK OPERATION 
    1. While carrying the electrical key transmitter sub-assembly, check that the entry unlock function operates when the back door opener switch is operated.

      Refer to OPERATION CHECK [10/2023 - ]

      Result

      Result Proceed to
      Entry lock/unlock function does not operate A
      Entry lock/unlock function operates B

    Result: 

    GO TO SMART KEY SYSTEM (Back Door Entry Lock and Unlock Functions do not Operate). Refer to  Back Door Entry Lock and Unlock Functions do not Operate [11/2018 - ]  

    Result: 

    GO TO POWER BACK DOOR SYSTEM (Power Back Door cannot be Operated Using Kick Sensor). Refer to  Power Back Door cannot be Operated Using Kick Sensor [10/2023 - ]