DTC P160F-00: Charging Control System [11/2018 - 10/2023]: Procedure
- CHECK DTC OUTPUT (CHARGING SYSTEM)
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine / Trouble Codes.
- Read the DTCs
Powertrain > Engine > Trouble Codes
Result
Result Proceed to Charging system DTCs are not output A Charging system DTCs are output B
Result:
B
GO TO CHARGING SYSTEM. Refer to DIAGNOSTIC TROUBLE CODE CHART [11/2018 - 10/2019] , or refer to DIAGNOSTIC TROUBLE CODE CHART [10/2019 - 10/2023]
Result:
A
See step 2
- CLEAR DTC
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Enter the following menus: Powertrain / Stop and Start / Trouble Codes.
- Clear the DTC.
Powertrain > Stop and Start > Clear DTCs
Result
Proceed to NEXT
Result:
NEXT
See step 3
- CHECK ANY OTHER DTCS OUTPUT
- Turn the ignition switch off and wait for 30 seconds or more.
- Turn the ignition switch to ON.
- Enter the following menus: Powertrain / Stop and Start / Trouble Codes.
- Read the DTCs.
Powertrain > Stop and Start > Trouble Codes
Result
Result Proceed to DTC P160F-00 is not output A DTC P160F-00 is output B
Result:
A
USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2018 - ]
Result:
B
REPLACE ENGINE STOP AND START ECU. Refer to REMOVAL [11/2018 - 10/2019] , or refer to REMOVAL [10/2019 - 08/2020] , or refer to REMOVAL [08/2020 - 10/2022] , or refer to REMOVAL [10/2022 - 10/2023]