Installation [11/2018 - 08/2020]: Procedure

INSTALL SPARK PLUG
Refer to PROCEDURE - Step 1
INSTALL IGNITION COIL ASSEMBLY
HINT:

Perform "Inspection After Repair" after replacing an ignition coil assembly.
- w/ Canister Pump Module:
  Refer to INITIALIZATION [11/2018 - 10/2019] , or refer to INITIALIZATION [10/2019 - 08/2020]
- w/o Canister Pump Module:
  Refer to INITIALIZATION [11/2018 - 08/2020]
1. Install the 4 ignition coil assemblies to the cylinder head cover sub-assembly with the 4 bolts.
  Torque: 7.5 N.m (76 kgf/cm, 66 in.lbf)
  
  NOTE:
  If an ignition coil assembly has been struck or dropped, replace it.
2. Connect the 4 ignition coil assembly connectors.
INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 76