DTC P0615-19: Starter Relay Circuit Current Above Threshold [11/2018 - 08/2020]: Description

When the engine is started by stop and start control, the engine stop and start ECU controls the starter assembly by activating the ST NO. 1 relay (for starter pinion operation) via voltage from terminal STA and then, using its built-in starter delay circuit, activating the ST NO. 2 relay (for starter motor operation) via voltage from terminal STA2.

If overcurrent is detected in the starter relay circuit, the engine stop and start ECU stores DTC P0615-19 and blinks the stop and start cancel indicator.

DTC No.	Detection Item	DTC Detection Condition	Trouble Area	Warning Indicate	Memory	Note
P0615-19	Starter Relay Circuit Current Above Threshold	Both of the following conditions are met for 1 second (1 trip detection logic): Ignition switch ON. Overcurrent to ST NO. 1 relay or ST NO. 2 relay is detected.	Wire harness or connector ST NO. 1 relay ST NO. 2 relay Engine stop and start ECU	Blinks	DTC stored	SAE Code: P0617