Installation [11/2018 - 02/2019]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSTALL KNOCK CONTROL SENSOR
HINT:
Perform "Inspection After Repair" after replacing the knock control sensor.
Refer to INITIALIZATION [11/2018 - 08/2020]
- Install the knock control sensor to the cylinder block sub-assembly with the bolt so that the knock control sensor installation position is as shown in the illustration.
Torque: 20 N.m (204 kgf/cm, 15 ft.lbf)
*a Top *b Right of Vehicle *c 15° *d 5° NOTE:- If the knock control sensor has been struck or dropped, replace it.
- Make sure that the knock control sensor is in the correct position.
- Connect the knock control sensor connector.
- Install the knock control sensor to the cylinder block sub-assembly with the bolt so that the knock control sensor installation position is as shown in the illustration.
- INSTALL INTAKE MANIFOLD
Refer to INSTALLATION [11/2018 - ]