Customize Parameters [10/2022 - ]

HINT: 

• The following PCS functions and the pre-collision system sensitivity setting can be changed from their default setting.
• Pre-collision system settings are shown in the Settings tab of the multi-information display.

1. Turn the ignition switch to ON.
2. Change pre-collision system settings by operating steering pad switch.
   PRE-COLLISION SYSTEM SETTINGS
   
   

   Display	Description	Setting	Default
   PCS*	Function that turns the pre-collision system ON or OFF	ON	ON or OFF
   Sensitivity	Function that selects the warning sensitivity of the pre-collision function	Middle	Early, Middle or Far

   *: Customization switching operations cannot be performed while driving.

HINT: 

The following customization settings allow retention of applicable operation settings for the PCS operation state and PCS warning sensitivity distance to be turned ON or OFF.

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Customize Setting / Others.
5. Select the setting by referring to the table below.

   Others 

   Tester Display	Description	Default	Setting	ECU
   PCS Function ON/OFF State Stored	Refer to the table below	Not Stored		Millimeter wave radar sensor assembly
   PCS Warning Timing State Stored 1	Refer to the table below	Not Stored		Millimeter wave radar sensor assembly
   PCS Warning Timing State Stored 2	Refer to the table below	Stored		Millimeter wave radar sensor assembly
   PCS Warning Timing State Stored 3	Refer to the table below	Not Stored		Millimeter wave radar sensor assembly

   Customize Setting	Description	Setting
   PCS Function ON/OFF State Stored	When the PCS function is OFF and the ignition switch is turned off and then to ON, this setting controls whether the prior PCS ON/OFF setting is retained.	Not Stored: PCS function resets to ON Stored: PCS function remains OFF
   PCS Warning Timing State Stored 1	When the ignition switch is ON and the PCS function is turned from off to ON, this setting controls whether the prior PCS warning sensitivity setting is retained.	Stored: Warning sensitivity is maintained at the previous value Not Stored: Warning sensitivity resets to "Mid"
   PCS Warning Timing State Stored 2	When the PCS function is ON and the ignition switch is turned off and then to ON, this setting controls whether the prior PCS warning sensitivity setting is retained.	Stored: Warning sensitivity is maintained at the previous value Not Stored: Warning sensitivity resets to "Mid"
   PCS Warning Timing State Stored 3	When the PCS function is OFF and the ignition switch is turned off and then to ON, this setting controls whether the prior PCS warning sensitivity setting is retained.	Stored: Warning sensitivity is maintained at the previous value Not Stored: Warning sensitivity resets to "Mid"