Sound Signal Circuit between Navigation Receiver Assembly and Stereo Component Amplifier [08/2015 - 08/2017]: Procedure

1. Disconnect the I26 navigation receiver assembly connector.
2. Disconnect the I17 stereo component amplifier assembly connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   I17-5 (R+) - I26-1 (FR+)	Always	Below 1 Ω
   I17-4 (R-) - I26-5 (FR-)	Always	Below 1 Ω
   I17-3 (L+) - I26-2 (FL+)	Always	Below 1 Ω
   I17-2 (L-) - I26-6 (FL-)	Always	Below 1 Ω
   I17-6 (SLD) - Body ground	Always	10 kΩ or higher
   I17-5 (R+) - Body ground	Always	10 kΩ or higher
   I17-4 (R-) - Body ground	Always	10 kΩ or higher
   I17-3 (L+) - Body ground	Always	10 kΩ or higher
   I17-2 (L-) - Body ground	Always	10 kΩ or higher

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE 

(Refer to PROBLEM SYMPTOMS TABLE [08/2015 - 08/2017] )

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR