LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2021 >> Sequoia TRD Pro >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Window Motors & Regulators >> Power Window Control System - Diagnostic Codes & Symptom Tests >> Power Window Control System >> Driver Side Power Window Auto Up / Down Function does not Operate with Power Window Master Switch [08/2015 - 08/2019] >> Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Driver Side Power Window Auto Up / Down Function does not Operate with Power Window Master Switch [08/2015 - 08/2019]: Procedure

  1. CHECK DTC 
    1. Check for DTCs (Refer to DTC CHECK / CLEAR [08/2015 - 08/2019] )
      RESULT

      Result Proceed to
      DTC is not output A
      B2311 is output B
      B2312 is output C
      B2313 is output D
      LIN communication system DTCs are output E

    Result: 

    GO TO DTC (B2311) 

    (Refer to DTC B2311: Power Window Motor Malfunction [08/2015 - 08/2019] )

    Result: 

    GO TO DTC (B2312) 

    (Refer to DTC B2312: Power Window Switch Malfunction [08/2015 - 08/2019] )

    Result: 

    GO TO DTC (B2313) 

    (Refer to DTC B2313: Glass Position Initialization Incomplete [08/2015 - ] )

    Result: 

    GO TO LIN COMMUNICATION SYSTEM 

    (Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - ] )

    Result: 

    See step  2

  2. CHECK MANUAL UP / DOWN FUNCTION 
    1. Check that the manual UP/DOWN function using the multiplex network master switch can operate the driver side power window (Refer to OPERATION CHECK [08/2015 - 08/2019] )

      OK

      Manual UP/DOWN function operates normally.

    Result: 

    NG 

    GO TO OTHER FLOW CHART (DRIVER SIDE POWER WINDOW MOTOR CIRCUIT) 

    (Refer to Driver Side Power Window does not Operate with Power Window Master Switch [08/2015 - 08/2017] , or refer to Driver Side Power Window does not Operate with Power Window Master Switch [08/2017 - 08/2019] )

    Result: 

    OK 

    See step  3

  3. READ VALUE USING TECHSTREAM (POWER WINDOW REGULATOR MASTER SWITCH) 
    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / Master Switch / Data List.
    5. According to the display on the Techstream, read the Data List.
      MASTER SWITCH

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      D Door P/W Auto SW Driver side power window auto UP/ DOWN switch signal / ON or OFF ON: Driver side power window auto UP/ DOWN switch operated
      OFF: Driver side power window switch not operated
      -

      OK

      The Techstream display changes normally when master switch is operated.

    Result: 

    OK 

    REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH 

    (Refer to REMOVAL [08/2015 - 08/2019] )

    Result: 

    NG 

    REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY 

    (Refer to REMOVAL [08/2015 - ] )