LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2021 >> Tundra SR, 4WD >> Repair and Diagnosis >> Body & Frame >> Windows >> Power Window Control System (W/ Jam Protection Function) - Diagnostics - Introduction >> POWER WINDOW CONTROL SYSTEM (w/ Jam Protection Function) >> Data List / Active Test [08/2015 - ] >> Data List / Active Test [08/2015 - ]
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Data List / Active Test [08/2015 - ]

  1. READ DATA LIST 

    HINT: 

    Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    NOTE:

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    1. Warm up the engine.
    2. Turn the ignition switch off.
    3. Connect the Techstream to the DLC3.
    4. Turn the ignition switch to ON.
    5. Turn the Techstream on.
    6. Enter the following menus: Body Electrical / (desired system) / Data List.
    7. According to the display on the Techstream, read the Data List.
      MASTER SWITCH

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      D Door P/W Auto SW Driver side power window auto UP/DOWN switch signal / ON or OFF ON: Driver side switch of master switch operated
      OFF: Driver side switch of master switch not operated      		 -
      P Door P/W Auto SW Front passenger side power window remote auto UP/DOWN switch signal / ON or OFF ON: Front passenger side switch of master switch operated
      OFF: Front passenger side switch of master switch not operated      		 -
      P Door P/W Up SW Front passenger side power window remote manual UP switch signal / ON or OFF ON: Front passenger side switch of master switch operated
      OFF: Front passenger side switch of master switch not operated      		 -
      P Door P/W Down SW Front passenger side power window remote manual DOWN switch signal / ON or OFF ON: Front passenger side switch of master switch operated
      OFF: Front passenger side switch of master switch not operated      		 -
      Window Lock Switch Status Power window LOCK switch / ON or OFF ON: Power window lock switch in LOCK position
      OFF: Power window lock switch in UNLOCK position      		 -
      Number of Trouble Codes Number of trouble codes / Min.: 0, Max.: 255 Number of DTCs will be displayed -
      D-DOOR MOTOR

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      D Door P/W Auto SW Driver side power window auto UP/DOWN switch signal / ON or OFF ON: Driver side switch operated
      OFF: Driver side switch not operated      		 -
      D Door P/W Up SW Driver side power window MANUAL UP switch signal / ON or OFF ON: Driver side switch operated
      OFF: Driver side switch not operated      		 -
      D Door P/W Down SW Driver side power window MANUAL DOWN switch signal / ON or OFF ON: Driver side switch operated
      OFF: Driver side switch not operated      		 -
      Number of Trouble Codes Number of trouble codes / Min.: 0, Max.: 255 Number of DTCs will be displayed -
      P-DOOR MOTOR

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      P Door P/W Auto SW Front passenger side power window auto UP/DOWN switch signal / ON or OFF ON: Power window regulator switch assembly operated
      OFF: Power window regulator switch assembly not operated      		 -
      P Door P/W Up SW Front passenger side power window manual UP switch signal / ON or OFF ON: Power window regulator switch assembly operated
      OFF: Power window regulator switch assembly not operated      		 -
      P Door P/W Down SW Front passenger side power window manual DOWN switch signal / ON or OFF ON: Power window regulator switch assembly operated
      OFF: Power window regulator switch assembly not operated      		 -
      Number of Trouble Codes Number of trouble codes / Min.: 0, Max.: 255 Number of DTCs will be displayed -
      MAIN BODY

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      D Door Courtesy SW Driver side door courtesy switch signal / ON or OFF ON: Driver door open
      OFF: Driver door closed      		 -
      P Door Courtesy SW Front passenger side door courtesy switch signal / ON or OFF ON: Front passenger door open
      OFF: Front passenger door closed      		 -
      Door Lock SW-Lock Driver side door lock switch signal / ON or OFF ON: Door control switch is pushed to lock position
      OFF: Door control switch is not pushed      		 -
      Door Lock SW-Unlock Driver side door unlock switch signal / ON or OFF ON: Door control switch is pushed to unlock position
      OFF: Door control switch is not pushed      		 -
      Door Key P/W Up Function to close the driver side door window while holding the key to the lock side for more than about 2.3 seconds / ON or OFF Customize setting displayed -
      Door Key P/W Down Function to open the driver side door window while holding the key to the unlock side for more than about 2.3 seconds / ON or OFF Customize setting displayed -
      Communication D-Door Motor Connection status between power window regulator motor (for driver side) and main body ECU / OK or Stop OK: Connection
      Stop: No connection      		 -
      Communication P-Door Motor Connection status between power window regulator motor (for front passenger side) and main body ECU / OK or Stop OK: Connection
      Stop: No connection      		 -
      Communication Master SW Connection status between master switch and main body ECU / OK or Stop OK: Connection
      Stop: No connection      		 -
      Door Key SW-Lock Door key linked lock switch signal / ON or OFF ON: Driver side door key cylinder is turned to lock position
      OFF: Driver side door key cylinder is not turned      		 -
      Door Key SW-Unlock Door key linked unlock switch signal / ON or OFF ON: Driver side door key cylinder is turned to unlock position
      OFF: Driver side door key cylinder is not turned      		 -
  2. PERFORM ACTIVE TEST 

    HINT: 

    Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

    1. Warm up the engine.
    2. Turn the ignition switch off.
    3. Connect the Techstream to the DLC3.
    4. Turn the ignition switch to ON.
    5. Turn the Techstream on.
    6. Enter the following menus: Body Electrical / (desired system) / Active Test.
    7. According to the display on the Techstream, perform the Active Test.
      WARNING:

      Be careful to avoid injuries as this test causes vehicle parts to move. During the Active Test, the jam protection function does not operate.

      D-DOOR MOTOR

      Tester Display Test Part Control Range Diagnostic Note
      Power Window Driver side power window OFF/UP/DOWN -
      P-DOOR MOTOR

      Tester Display Test Part Control Range Diagnostic Note
      Power Window Front passenger side power window OFF/UP/DOWN -
      MAIN BODY

      Tester Display Test Part Control Range Diagnostic Note
      IG OFF P/W Control Permission Output Power window control permission output ON or OFF -
scientia non olet · About LEMON Manuals