Front Passenger Side Power Window Auto Up / Down Function does not Operate with Front Passenger Side Power Window Switch [07/2020 - ]: Procedure
- READ VALUE USING GTS (P-DOOR MOTOR)
- Read the Data List according to the display on the GTS.
Body Electrical > P-Door Motor > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note P Door P/W Auto SW Front passenger door power window auto switch signal OFF or ON OFF: Front passenger door power window auto up or auto down switch not being operated
ON: Front passenger door power window auto up or auto down switch being operated- Body Electrical > P-Door Motor > Data List
Tester Display P Door P/W Auto SW OK
On the GTS screen, ON or OFF is displayed accordingly.
Result
Proceed to OK NG
Result:
NG
See step 4
Result:
OK
See step 2
- Read the Data List according to the display on the GTS.
- PERFORM INITIALIZATION (for Front Passenger Door)
- Initialize the power window regulator motor assembly (for front passenger door).
Refer to INITIALIZATION [07/2020 - ]
Result
Proceed to NEXT
Result:
NEXT
See step 3
- Initialize the power window regulator motor assembly (for front passenger door).
- CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP / DOWN FUNCTION)
- Check that the front passenger door power window moves when the auto up and down functions of the power window regulator switch assembly are operated.
Refer to OPERATION CHECK [07/2020 - ]
OK
Front passenger door auto up and down functions are normal.
Result
Proceed to OK NG
Result:
OK
END (PROBLEM DUE TO INITIALIZATION FAILURE)
Result:
NG
REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Front Passenger Door). Refer to REMOVAL [07/2020 - 10/2022] , or refer to REMOVAL [10/2022 - ]
- Check that the front passenger door power window moves when the auto up and down functions of the power window regulator switch assembly are operated.
- INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY
Refer to INSPECTION [07/2020 - ]
Result
Proceed to OK NG Result:
NG
REPLACE POWER WINDOW REGULATOR SWITCH ASSEMBLY. Refer to REMOVAL [07/2020 - ]
Result:
OK
See step 5
- CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR SWITCH ASSEMBLY - POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Front Passenger Door))
- Disconnect the G5 power window regulator motor assembly (for front passenger door) connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition I3-8 (AUTO) - G5-4 (AUTO) Always Below 1 Ω I3-8 (AUTO) or G5-4 (AUTO) - Body ground Always 10 kΩ or higher Result
Proceed to OK NG
Result:
OK
REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Front Passenger Door). Refer to REMOVAL [07/2020 - 10/2022] , or refer to REMOVAL [10/2022 - ]
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR