DTC C1AC2: Slave Module Horizontal Axis Misalignment [08/2021 - ]: Procedure

CHECK INSTALLATION CONDITION
1. Check the installation condition of the blind spot monitor sensor RH.
  Refer to ADJUSTMENT [08/2021 - ]
  
  HINT:
  
  Take the appropriate action in accordance with the result.
Result:

NEXT

See step 2
PERFORM BEAM AXIS CONFIRMATION
1. Install the rear bumper.
  - w/ Mudguard
    Refer to INSTALLATION [08/2021 - ]
  - w/o Mudguard
    Refer to INSTALLATION [08/2021 - ]
2. Perform Blind Spot Monitor Beam Axis Confirmation using the Techstream.
  Refer to ADJUSTMENT [08/2021 - ]
Result:

OK

END

Result:

NG

REPLACE BLIND SPOT MONITOR SENSOR RH. Refer to REMOVAL [08/2021 - ]