DTC U0163-87: Lost Communication with Navigation Control Module Missing Message [11/2022 - ]: Procedure

HINT: 

This utility is used to initialize the navigation installation information stored in the front recognition camera.

1. Following the instructions on the GTS, perform "Navigation Installation Information Initialization".

   Chassis > Front Recognition Camera > Utility 

   Tester Display
   Navigation Installation Information Initialization

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  2

1. Clear the DTCs.

   Chassis > Front Recognition Camera > Clear DTCs 

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  3

Pre-procedure1

1. Make sure that the DTC detection conditions are met.

   HINT: 

   If the detection conditions are not met, the system cannot detect the malfunction.

   Procedure1

2. Check for DTCs.

   Chassis > Front Recognition Camera > Trouble Codes 

   Result

   Result	Proceed to
   CAN communication system DTC is not output	A
   CAN communication system DTC is output	B

   Post-procedure1

3. None.

Result: 

A 

USE SIMULATION METHOD TO CHECK 

Refer to HOW TO PROCEED WITH TROUBLESHOOTING [06/2018 - ]

Result: 

B 

GO TO CAN COMMUNICATION SYSTEM 

for Gasoline Model: Refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2022 - 08/2023] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2023 - 09/2024] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [09/2024 - ]

for HV Model: Refer to HOW TO PROCEED WITH TROUBLESHOOTING [09/2022 - ]