LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2023 >> GR86 Base, Automatic Trans >> Repair and Diagnosis (Single Page) >> Body & Frame >> Windows >> Power Window Control System - Diagnostic Codes & Symptom Tests >> Power Window Control System >> When the Driver's Switch is Operated, the Driver's Side Power Window does not Work in Automatic Operation [11/2021 - ] >> Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

When the Driver's Switch is Operated, the Driver's Side Power Window does not Work in Automatic Operation [11/2021 - ]: Procedure

  1. CHECK MALFUNCTIONS 
    1. Turn the ignition switch to ON.
    2. Operate the power window regulator master switch assembly and check that the power window (driver's side) works in manual operation.

      Does the power window operate manually according to switch operation?

      Result Proceed to
      YES A
      NO B

    Result: 

    PERFORM THE DIAGNOSIS FOR "WHEN THE DRIVER'S SWITCH IS OPERATED, THE DRIVER'S SIDE POWER WINDOW DOES NOT WORK IN MANUAL OPERATION". Refer to  When the Driver's Switch is Operated, the Driver's Side Power Window does not Work in Manual Operation [11/2021 - ]  

    Result: 

    See step  2

  2. CHECK DTC 
    1. Using the GTS, read the DTCs of [Power Window (Switch)] and [Power Window (Driver)].

      Body Electrical > Power Window (Switch) > Trouble Codes 

      Body Electrical > Power Window (Driver) > Trouble Codes 

      Are any DTCs displayed?

      Result Proceed to
      YES A
      NO B

    Result: 

    PERFORM THE DIAGNOSIS FOR THE DISPLAYED DTCS 

    Result: 

    See step  3

  3. CHECK [ECU CONTROL MODE] (DATA LIST) 
    1. Using the GTS, check the following items in the [Data List] of [Power Window (Driver)].

      Body Electrical > Power Window (Driver) > Data List 

      Tester Display Measurement Item Range Diagnostic Note
      ECU Control Mode ECM control status Uninitialized 1
      No Definition
      Uninitialized 2
      Initialized
      -

      Body Electrical > Power Window (Driver) > Data List 

      Tester Display
      ECU Control Mode

      Is [Initialized] displayed?

      Result Proceed to
      YES A
      NO B

    Result: 

    USING THE GTS, PERFORM [SYSTEM INITIALIZATION] OF [POWER WINDOW (DRIVER)] 

    Refer to UTILITY [11/2021 - ]

    Then, perform the initial setting of the power window.

    Refer to REGISTRATION [11/2021 - ]

    Result: 

    See step  4

  4. CHECK [ONE'S SEAT SWITCH] (DATA LIST) 
    1. Using the GTS, check the following items in the [Data List] of [Power Window (Driver)].

      Body Electrical > Power Window (Driver) > Data List 

      Tester Display Measurement Item Range Diagnostic Note
      One's Seat Switch Status of switch at passenger's own seat OFF
      DOWN
      UP
      UP/DOWN
      AUTO
      AUTO DOWN
      AUTO UP
      UP/DOWN/AUTO
      -

      Body Electrical > Power Window (Driver) > Data List 

      Tester Display
      One's Seat Switch

      Does the display change corresponding to the switch operation?

      Result Proceed to
      YES A
      NO B

    Result: 

    REPLACE THE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH. Refer to  REMOVAL [11/2021 - ] 

    Result: 

    REPLACE THE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY. Refer to  REMOVAL [11/2021 - ]