DTC B00C0-28: Passenger Seat Occupant Classification Sensor "A" Signal Bias Level Out of Range / Zero Adjustment Failure [12/2022 - ]: Procedure

1. Using the GTS, perform "Occupant Detection Sensor Zero Point Calibration".

   HINT: 

   Refer to INITIALIZATION [12/2022 - ]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  2

Pre-procedure1

• Turn the ignition switch to ON, and wait for at least 60 seconds.

• Clear the DTCs stored in memory.

  Body Electrical > SRS Airbag > Clear DTCs 

  Result

  Proceed to
  NEXT

Post-procedure1

• Turn the ignition switch off.

Result: 

NEXT 

See step  3

Pre-procedure1

• Turn the ignition switch to ON, and wait for at least 60 seconds.

• Check the DTCs.

  Body Electrical > SRS Airbag > Trouble Codes 

  Result

  Result	Proceed to
  B00C0-28 is output	A
  B00C0-28 is not output	B

Post-procedure1

• None

Result: 

B 

END (NORMAL AFTER PERFORMING ZERO POINT CALIBRATION) 

Result: 

A 

See step  4

Pre-procedure1

• Turn the ignition switch off.
• Disconnect the cable from the negative (-) auxiliary battery terminal, and wait for at least 60 seconds.

• Replace the front seat adjuster assembly RH with a new one.

  HINT: 

  Refer to REMOVAL [12/2022 - 03/2023] , or refer to REMOVAL [03/2023 - ]

  Result

  Proceed to
  NEXT

Post-procedure1

• Connect the cable to the negative (-) auxiliary battery terminal, and wait for at least 2 seconds.

Result: 

NEXT 

See step  5

1. Using the GTS, perform "Occupant Detection Sensor Zero Point Calibration".

   HINT: 

   Refer to INITIALIZATION [12/2022 - ]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

END (FRONT SEAT ADJUSTER ASSEMBLY RH WAS DEFECTIVE)