LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2023 >> Prius LE AWD >> Repair and Diagnosis (Single Page) >> Transmission >> Transmission Control Systems >> Electronic A/T Shift Lever System - Diagnostic Codes & Circuit Tests >> Electronic Shift Lever System >> DTC P2E00-64: Gear Lever Position Sensor "A" Signal Plausibility Failure; DTC P2E04-64: Gear Lever Position Sensor "B" Signal Plausibility Failure; DTC P2E08-64: Gear Lever Position Sensor "C" Signal Plausibility Failure [12/2022 - ] >> Confirmation Driving Pattern
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Confirmation Driving Pattern

HINT: 

After repairs have been completed, clear the DTCs and then check that the vehicle has returned to normal by performing the All Readiness check procedure.

Refer to UTILITY [12/2022 - ]

  1. Turn the ignition switch to ON (READY) and wait for 1 minute or more.
  2. Turn all switches off and turn the ignition switch off.
  3. Disconnect the GTS.
  4. Wait for 5 minutes or more with the door lock locked.

    HINT: 

    • Once the door lock is locked, keep the electrical key transmitter sub-assembly (electrical key) 3 m (9.84 ft.) or more away from the vehicle.
    • Because the system will not sleep while any door and/or the hood is open, take steps such as securing the courtesy switch to make the system recognize the doors and hood as closed when carrying out the operation.
    • If the vehicle is equipped with a power back door, the system will not sleep if the back door is not closed. Ensure that the back door is closed before carrying out the operation.
  5. Turn the ignition switch to ON (READY) and wait for 1 minute or more.
scientia non olet · About LEMON Manuals