LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2023 >> Tundra Capstone >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Stop And Start System Cancel Switch Assembly - Service Information >> Stop And Start System Cancel Switch Assembly >> Removal [11/2021 - ] >> Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal [11/2021 - ]: Procedure

  1. REMOVE FRONT DOOR SCUFF PLATE LH 

    Refer to PROCEDURE - Step 1

  2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH 

    Refer to PROCEDURE - Step 2

  3. REMOVE INSTRUMENT SIDE PANEL LH 

    Refer to PROCEDURE - Step 8 [11/2021 - 05/2022] , or refer to PROCEDURE - Step 8 [05/2022 - 08/2024] , or refer to PROCEDURE - Step 8 [08/2024 - ]

  4. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY 
    Refer to PROCEDURE - Step 3
  5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH 
    Refer to PROCEDURE - Step 19 [11/2021 - 05/2022] , or refer to PROCEDURE - Step 19 [05/2022 - 08/2024] , or refer to PROCEDURE - Step 19 [08/2024 - ]
  6. REMOVE ECO RUN CANCEL SWITCH ASSEMBLY 
    1. GTY1042316Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction - -
      1. Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws and remove the eco run cancel switch assembly from the lower instrument panel finish panel sub-assembly as shown in the illustration.
scientia non olet · About LEMON Manuals