Installation [05/2022 - ]: Procedure

INSTALL ECM

Install the ECM with the 3 bolts.
Torque: 13 N.m (133 kgf/cm, 10 ft.lbf)

NOTE:
If the ECM has been struck or dropped, replace it.
Attach the 2 wire harness clamps.
Connect the 3 connectors to the ECM and push down the lever to lock it.
Attach the 2 wire connector clamps.

INSTALL AIR WITH ELEMENT CLEANER ASSEMBLY LH
CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
WRITE VIN
1. for HEV Model
  Refer to REGISTRATION [05/2022 - ]
2. for Gasoline Model
  Refer to REGISTRATION [11/2021 - ]
HINT:

It requires when replacing the ECM.
ECU CONFIGURATION
Refer to ECU CONFIGURATION [05/2022 - ]

HINT:

It requires when replacing the ECM.
UPDATE ECU SECURITY KEY
Refer to UPDATE ECU SECURITY KEY [11/2021 - ]

HINT:

It requires when replacing the ECM.
WORK PROCEDURES AFTER PARTS INSTALLED
Refer to WORK PROCEDURE [05/2022 - 09/2022] , or refer to WORK PROCEDURE [09/2022 - 08/2023] , or refer to WORK PROCEDURE [08/2023 - 08/2024] , or refer to WORK PROCEDURE [08/2024 - ]
WORK PROCEDURES AFTER BATTERY RECONNECTED
HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Refer to AUTOMATIC LEARNING CHART [05/2022 - 08/2024] , or refer to AUTOMATIC LEARNING CHART [08/2024 - ]