LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2024 >> Land Cruiser Base >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Control System - Diagnostic Codes (5 Of 9) >> SFI System >> DTC P0606-94: Control Module Processor Unexpected Operation [02/2024 - ] >> Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC P0606-94: Control Module Processor Unexpected Operation [02/2024 - ]: Procedure

  1. CLEAR DTC 

    Pre-procedure1

    1. None

      Procedure1

    2. Clear the DTCs.

      Powertrain > Engine > Clear DTCs 

      Result

      Proceed to
      NEXT

      Post-procedure1

    3. Turn the ignition switch off.

    Result: 

    NEXT 

    See step  2

  2. READ OUTPUT DTC (DTC P0606-94) 

    Pre-procedure1

    1. Disconnect the cable from the negative (-) auxiliary battery terminal and wait for 1 minute.
    2. Connect the cable to the negative (-) auxiliary battery terminal.
    3. Turn the ignition switch to ON (READY).
    4. While the engine is running, repeat the accelerator pedal operation (press the accelerator pedal from a state where it is not depressed) several times.
    5. Drive the vehicle.

      Procedure1

    6. Read the DTCs.

      Powertrain > Engine > Trouble Codes 

      Result

      Result Proceed to
      DTCs are not output A
      P0606-94 is output B

      Post-procedure1

    7. None

    Result: 

    A 

    CHECK FOR INTERMITTENT PROBLEMS 

    Refer to HOW TO PROCEED WITH TROUBLESHOOTING [02/2024 - ]

    Result: 

    B 

    See step  3

  3. CHECK HARNESS AND CONNECTOR (ACCELERATOR PEDAL SENSOR ASSEMBLY - ECM) 

    Pre-procedure1

    1. Disconnect the accelerator pedal sensor assembly connector.
    2. Disconnect the ECM connector.

      Procedure1

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      A23-6 (VPA) - A9-85 (VPA) Always Below 1 Ω
      A23-3 (VPA2) - A9-88 (VPA2) Always Below 1 Ω
      A23-4 (VCPA) - A9-87 (VCPA) Always Below 1 Ω
      A23-1 (VCP2) - A9-90 (VCP2) Always Below 1 Ω
      A23-5 (EPA) - A9-86 (EPA) Always Below 1 Ω
      A23-2 (EPA2) - A9-89 (EPA2) Always Below 1 Ω
      A23-6 (VPA) or A9-85 (VPA) - Body ground and other terminals Always 10 kΩ or higher
      A23-3 (VPA2) or A9-88 (VPA2) - Body ground and other terminals Always 10 kΩ or higher
      A23-4 (VCPA) or A9-87 (VCPA) - Body ground and other terminals Always 10 kΩ or higher
      A23-1 (VCP2) or A9-90 (VCP2) - Body ground and other terminals Always 10 kΩ or higher
      A23-5 (EPA) or A9-86 (EPA) - Body ground and other terminals Always 10 kΩ or higher
      A23-2 (EPA2) or A9-89 (EPA2) - Body ground and other terminals Always 10 kΩ or higher

      Result

      Proceed to
      OK
      NG

      Post-procedure1

    4. None

    Result: 

    OK 

    REPLACE ECM 

    Refer to REMOVAL [02/2024 - ]

    Result: 

    NG 

    REPAIR OR REPLACE HARNESS OR CONNECTOR 

scientia non olet · About LEMON Manuals