Caution / Notice / Hint
NOTE:
- If the power window regulator motor assembly LH (for front door) has been replaced with a new one, initialize the power window control system.
Refer to REGISTRATION [12/2024 - ]
- The power window control system uses the LIN communication system. Troubleshoot the power window control system after confirming that the communication system is functioning properly.
Refer to "LIN Communication System".
- Check that power window system customize setting "D Window Auto Up Function" and "D Window Auto Down Function" are set to "Enable" before performing the following procedure.
Refer to CUSTOMIZE PARAMETERS [12/2024 - ]
- After the catch protection function has operated, the auto up function will not operate the first time the power window auto up switch is operated. The auto up function will operate normally after the first power window switch operation.
HINT:
If the pulse sensor built into the power window regulator motor assembly LH (for front door) is malfunctioning, the power window control system will enter fail-safe mode. The remote up and down and auto up and down functions cannot be operated during fail-safe mode. However, the power window can be closed by holding the multiplex network master switch assembly at the auto up position, and opened manually by pushing down the multiplex network master switch assembly.