DTC P2402: EVAP System Leak Detection Pump Control Circuit High [11/2021 - ]: Procedure

1. Turn the ignition switch to OFF.
2. Disconnect the connector from the canister pump module.
3. Turn the ignition switch to ON.
4. Measure the voltage between the canister pump module connector and chassis ground.

   Connector & terminal

   M23-4 - Chassis ground

   Is the voltage 10 V or higher?

   Result	Proceed to
   Yes (Repair the short circuit to power in harness between ECM connector and canister pump module connector.)	A
   No	B

Result: 

A 

REPAIR HARNESS OR CONNECTOR 

Result: 

B 

REPLACE CANISTER PUMP MODULE 

Refer to PROCEDURE - Step 5