LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2025 >> GR86 Base, Standard Trans >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Anti-Theft Systems >> Keyless Access System - Diagnostics - Introduction >> Keyless Access System With Push Button Start >> Customize Parameters [11/2021 - ] >> Customize Parameters [11/2021 - ]
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Customize Parameters [11/2021 - ]

  1. KEYLESS ACCESS SYSTEM WITH PUSH BUTTON START 

    Smart Key / Access 

    Tester Display Description Default Setting ECU
    Trunk Open Without Key OFF: When the vehicle is unlocked, trunk cannot be opened when smart key is not carried.
    ON: When the vehicle is unlocked, trunk can be opened even when smart key is not carried.    		 ON $00:OFF,$FF:ON -
  2. DISABLING/ACTIVATING THE KEYLESS ACCESS SYSTEM 
    1. The following functions are disabled when the keyless access system functions are disabled:
      • LOCK function performed by the operation of touch sensor on the door outer handle
      • UNLOCK function by holding the door handle
      • Trunk lid open function by luggage door opening switch assembly operation in the trunk lid lock condition
      • Keyless access warning function
      • Engine starting control using keyless access collation
    2. Stopping keyless access system function by door open/close procedure
      1. Check that the vehicle status is as follows:
        • Ignition switch OFF
        • One window is completely open
        • Keyless access system is activated (or disabled if re-activating)
      2. Sit in the driver's seat with the door closed and press the door lock switch to UNLOCK once.
      3. Open the driver's door within five seconds.
      4. Within 5 seconds, with the driver's door opened, slowly press the door lock switch to UNLOCK twice.
      5. Within 10 seconds after finishing step 4., perform the closing → opening operation of the driver's door twice.
      6. Within 10 seconds after finishing step 5., with the driver's door opened, slowly press the door lock switch to UNLOCK twice.
      7. Within 10 seconds after finishing step 6., perform the closing → opening operation of the driver's door once.
      8. Within five seconds after finishing step 7., close the driver's door.
      9. The buzzer sounds for two seconds, and the function stops.
        NOTE:
        • Perform the same procedures to re-activate the keyless access system from the disabled condition.
        • In step 4. and step 6., press the door lock switch completely. The function may not work properly if the switch is pressed shortly.
    3. Stopping keyless access system function by using electrical key transmitter sub-assembly
      1. Open the driver's door, and then push the door lock knob forward (LOCK direction).
      2. Press the lock button of electrical key transmitter sub-assembly and trunk button simultaneously for five seconds or more.
      3. The buzzer sounds for two seconds, and the function stops.
        NOTE:
        • For stopping the keyless access system function by using electrical key transmitter sub-assembly, it is necessary to ask the customer to register the secret code of the secret code keyless entry. (Refer to owner's manual for details.)
        • Perform the same procedures to re-activate the keyless access system from the disabled condition.
scientia non olet · About LEMON Manuals